Can I print the booklet is cheap, without losing quality? There are at least three ways to reduce the cost of printing the booklet, regardless of its circulation. Savings do not affect the appearance of the finished product. The price for printing the booklet consists of several components. The most expensive part is the use of materials – paper and ink. The cost of finishing several times lower, despite the fact that it includes several operations – creasing, folding, die cutting, varnishing, etc. Development of design compared to the total cost of materials and finishing is quite inexpensive. However, it depends on the design on which the paper will be printed your booklet, and how many colors will be used to print it. Where are the savings? The first thing you should pay attention – is the density of paper. The lower, the lower the final cost of the entire run. For example, A4 booklet for the (two-fold) is sufficient paper density 150-170 g / m . Paper 250 g / m will cost 1.5-2 times more expensive. With the amount of kraskoprogonov also need to observe moderation. Here, as in the case of the paper: the fewer colors, the cheaper. Especially, in order to make the booklet inexpensive, but qualitatively, it takes only two colors. For example, red and black. Out very nicely even. Save a little? Here's another way to reduce costs. When printing a booklet not apply UV varnish and lamination. The coating will prolong the "life" booklet is not worse than the "varnishing", and would cost considerably less. Should I save money on designer? In principle, the "tailoring" can be on anything. The main thing that economy was not excessive and did not turn around the loss of product quality. Success!